DIGITAL-LOGIC MICROSPACE MSM286 Series Technical User's Manual page 44

DIGITAL-LOGIC AG
10 S
OFTWARE TOOLS AND DRIVERS
The tooldisk is divided into the following subdirectories:
MS286
10.1 HMA Driver for DOS V5.x:HIDOS.SYS
HIDOS.SYS is a device driver for PC/Chip that allows MS-DOS 5.0 to be loaded in HMA (above 1
MB).
The following two lines should be added to the CONFIG.SYS file:
DEVICE = HIDOS.SYS
DOS = HIGH
10.2 The EMS Driver: PCCEMM.SYS
This EMS driver is supplied as a device driver that can be loaded at DOS boot time. The user is re-
quired to edit the CONFIG.SYS file so that it contains a line in the form of:
DEVICE = d:[path]\PCCEMM.SYS [options]
where D: and [path] represent the drive and path where the driver is located. The driver is designed
so that, under normal circumstances, it does not need any command line options in order to give sat-
isfactory performance. However, command line options are provided so that the driver may be tai-
lored to a user's specific needs.
The following command line parameters are available for knowledgeable users who wish to tailor the
driver for their own requirements. Option names may be shortened to their first two characters. Op-
tions should be separated by one or more spaces. Spaces are optional before and after the '-' and '='
symbols.
HANDLES = hhh Specifies the number of handles and names available. "hhh" must be in the
range of 16 to 255, with the default being 64.
IOADDR = aaa Overrides the default base I/O address at which the PC/CHIP should be con-
figured. aaa can be 208, 218, 258, 268, 2A8, 2B8, or 2E8.
DIAGS = xxx Specifies whether EMS memory diagnostics are performed during initialization
of the driver. "xxx" must be ON or OFF. The default =OFF.
TOOLS
SETUPPCC.EXE
F8680.EXE
HDMEM.COM
HD.COM
C&T
MINIBUG.COM
PCCEMM.SYS and .TXT
HIDOS.SYS and .DOC
KEYSCAN
KEYEDIT.EXE
LOADK132.EXE
LOADK220.EXE
KMATRIX.DAT
(Key editor)
(for BIOS V1.3.2.)
(for BIOS V220)
(Key file)
44
MSM286 Manual V6.4