NSD ABSOCODER NPG-220HZCLC Specifications & Instruction Manual page 32

9. OPERATION
9-1. Operation Sequence
Function selector switch
Designate the following setting by a switch which is at
rear face of the converter.
1. Designate the common function selector switch "SW3"
for both axes.
2. Designate the function selector switch "SW1" and "SW2"
for each axis.
Converter mounting
Mounting the converter.
Connect the converter to the power supply.
Connect with external device
Connect ABSOCODER sensor and control device to the
converter.
Test run
Check the operation.
Operation
Execute operation.
START
END
26
-------- Refer to section 9-2.
-------- Refer to section 6-1 and 7-2.
-------- Refer to section 7-1 and 7-3.