ST STM32WBA65I-DK1 User Manual page 33

11 Federal Communications Commission (FCC) and ISED Canada
Compliance Statements
11.1 FCC Compliance Statement
Identification of products: STM32WBA65I-DK1
Contains FCC ID: YCP-MB213000
Part 15.19
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Part 15.21
Any changes or modifications to this equipment not expressly approved by STMicroelectronics may cause
harmful interference and void the user's authority to operate this equipment.
Part 15.105
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception which can be determined by turning the equipment off and on,
the user is encouraged to try to correct interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Use only shielded cables.
To satisfy FCC RF exposure requirements, a separation distance of 20 cm or more should be maintained between
the antenna of this device and persons during operation. To ensure compliance, operation at a closer distance
than this is not recommended. This transmitter must not be collocated or operating in conjunction with any other
antenna or transmitter.
Responsible Party – U.S. Contact Information:
Francesco Doddo
STMicroelectronics, Inc.
200 Summit Drive | Suite 405 | Burlington, MA 01803
USA
Telephone: +1 781-472-9634
UM3462 - Rev 1
Federal Communications Commission (FCC) and ISED Canada Compliance Statements
UM3462
page 33/43