ST STM32WBA65I-DK1 User Manual page 27

7.12 Jumper overview
Reference
JP1
JP2
JP3
JP4
UM3462 - Rev 1
Table 9.
Default position
OFF STLINK-V3EC reset, active low
Jumper for MCU current measurement.
MCU current measurement can be performed on JP2. By default, JP2 is ON.
ON
For the current measurement configuration, an ammeter must replace the JP2
jumper.
MCU boot mode selection
OFF
By default, BOOT0 at a low level to boot on internal flash memory
5V_STLK Board power source selection. Refer to
Jumper reference table
Comment
Section
UM3462
Hardware layout and configuration
7.2.
page 27/43