Icom IC-M9 Instruction Manual page 15

—
SET MODE ©
Mi SET mode programming
SET mode is used to change the conditions of 3 transceiver
functions: the power saver function, the dual/tri-watch func-
tion and the scan function.
T mode items
Power saver
OFF The power saver function
helps conserve battery
1) Turn power OFF. Power saver | Power by automatically
duty cycle resting the receiver circuit
1:4 when the transceiver is idle.
For maximum battery
conservation, choose the
Power saver | highest duty cycle:
2) While pushing [HI/LOW], turn power ON and continue
pushing [HI/LOW] until the display appears.
3) After the display appears, release [HI/LOW].
1:8
4) Push [HI/LOW] to select the desired item, if necessary.
5) Rotate the channel selector to select the desired condi-
ee ee
tion of the item as shown in the table at right. channel (16) while scanning.
arte PAI er MO pean
l l 1
Dual watch | Choose tri-watch if you want
e Turning power OFF, then ON again also exits SET mode. operation fo-moniter the calichannelin
These displays show the default settings. Tri-watch addition to channel 16 and a