Icom IC-M9 Instruction Manual page 17

SCAN FUNCTIONS 6
W Channel lockout
For more efficient scanning, set unwanted channels as
lockout channels. Channels set as lockout channels will be
skipped during scanning. Channel lockout is assigned to
regular channels and memory channels independently.
1) Select the channel to be locked out (either a regular
channel or a memory channel).
e Channel 16 or the call channel cannot be locked out.
2) While pushing [HI/LOW], push [DW(SCAN)].
e " " ‫ ا ل‬‎ appears in the function display
and the channel is locked out.
3) To unlock a channel, repeat
This example shows a
step 2) above. regular channel
locked out.
Scan pauses when receiving a Push to stop the
signal and audio is emitted. scan.
Push for 2 secs. Scan starts
Set priority scan or normal scan in advance using SET
mode (see pgs. 12).
1) Make sure channel 16 or the call channel is not selected.
e Select a regular channel or memory channel (see p. 8).
2) Push and hold [DW/(SCAN)] for 2 seconds.
e "SCAN" appears in the function display.
e When a priority scan is selected "16" appears instead of the
memory channel.
e When a signal is detected, scan pauses until the signal disap-
pears. (Ch 16 is still monitored during priority scan.)
3) To stop the scan, push [DW(SCAN)].
e "SCAN" disappears.
e Pushing [16] or [C/M] also stops the scan.
Starting a scan (example — normal scan of regular channels):
Push [16] or [C/M]
once or twice if
channel 16, the
call channel or
memory mode is
selected.
‫ا‬