Troubleshooting An Internal Sd Card - Dell PowerEdge T710 Hardware Owner's Manual

Troubleshooting an Internal SD Card

WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Enter the System Setup program and ensure that the internal SD card port
is enabled. See "Integrated Devices Screen" on page 64.
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
3 Open the system. See "Opening the System" on page 85.
4 Reseat the internal SD module cable. See "Installing the Internal SD
Module" on page 119.
5 Locate the SD card and reseat it. See "Removing an Internal SD Flash
Card" on page 122 and "Installing an Internal SD Flash Card" on page 122.
6 Close the system. See "Closing the System" on page 86.
7 Place the system upright and on its feet on a flat and stable surface,
reconnect the system to the electrical outlet, turn on the system and
attached peripherals, and check if the SD card is functioning.
8 If the problem is not resolved, repeat step 2 and step 3.
9 Insert a different SD card that you know works properly.
10 Close the system. See "Closing the System" on page 86.
11 Place the system upright and on its feet on a flat and stable surface,
reconnect the system to the electrical outlet, turn on the system and
attached peripherals, and check if the SD card is functioning.
If the problem is not resolved, see "Getting Help" on page 193.
Only trained service technicians are authorized to remove the system
Troubleshooting Your System
169