Internal Usb Memory Key - Dell PowerEdge T710 Hardware Owner's Manual

4 Locate the SD card slot in the internal SD module and press inward on
the card to release it from the slot and remove the card.
5 Close the system. See "Closing the System" on page 86.
6 Place the system upright and on its feet on a flat, stable surface.
7 Rotate the system feet outward.
8 Reattach any peripherals, then connect the system to the electrical outlet.
9 Turn on the system and attached peripherals.

Internal USB Memory Key

An optional USB memory key installed inside your system can be used as a
boot device, security key, or mass storage device.
WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 85.
4 Locate the USB connector on the system board. See Figure 6-1.
5 Insert the USB memory key into the USB connector. See Figure 3-19.
6 Close the system. See "Closing the System" on page 86.
7 Place the system upright and on its feet on a flat, stable surface.
8 Rotate the system feet outward.
9 Reattach any peripherals and connect the system to an electrical outlet.
Only trained service technicians are authorized to remove the system
Installing System Components
123