Removing An Idrac6 Enterprise Card - Dell PowerEdge T710 Hardware Owner's Manual

Figure 3-26. Removing and Installing an iDRAC6 Enterprise Card
1
2
1 iDRAC6 Enterprise card
3 iDRAC6 Enterprise card connector
5 VFlash media slot

Removing an iDRAC6 Enterprise Card

WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 85.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 87.
5 Remove the fan modules. See "Removing a Cooling-Fan Module" on
page 136.
6 Remove the fan cage. See "Removing the Fan Cage" on page 138.
142
Installing System Components
3
Only trained service technicians are authorized to remove the system
4
2 retention standoff tabs (2)
4 retention standoff posts (2)
6 VFlash SD card
6
5