Dell PowerEdge T710 Hardware Owner's Manual page 105

Figure 3-11. Installing and Removing a Memory Module
1 memory module
3 alignment key
7 Align the memory module's edge connector with the alignment key of the
memory module socket, and insert the memory module in the socket.
NOTE:
install the memory module in the socket in only one way.
8 Press down on the memory module with your thumbs until the socket
levers latch into a locked position.
When the memory module is properly seated in the socket, the levers on
the memory module socket align with the levers on the other sockets that
have memory modules installed.
9 Repeat step 5 through step 8 of this procedure to install the remaining
memory modules. See Table 3-1 or Table 3-2.
10 Install the cooling shroud. See "Installing the Cooling Shroud" on page 88.
11 Close the system. See "Closing the System" on page 86.
12 Place the system upright and on its feet on a flat, stable surface.
13 Rotate the system feet outward.
The memory module socket has an alignment key that allows you to
2 memory module socket levers (2)
Installing System Components
1
2
3
105