Troubleshooting The Processors - Dell PowerEdge T710 Hardware Owner's Manual

13 For each expansion card you removed in step 9, perform the following
steps:
Turn off the system and attached peripherals, and disconnect the
a
system from the electrical outlet.
Open the system. See "Opening the System" on page 85.
b
Reinstall one of the expansion cards.
c
Close the system. See "Closing the System" on page 86.
d
Place the system upright and on its feet on a flat and stable surface,
e
reconnect the system to the electrical outlet, and turn on the system
and attached peripherals.
Run the appropriate diagnostic test.
f
If the tests fail, see "Getting Help" on page 193.

Troubleshooting the Processors

WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Run the appropriate online diagnostics test. See "Running the System
Diagnostics" on page 181.
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
3 Open the system. See "Opening the System" on page 85.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 87.
5 Ensure that each processor and heat sink are properly installed. See
"Installing a Processor" on page 110.
6 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 88.
7 Close the system. See "Closing the System" on page 86.
8 Place the system upright and on its feet on a flat and stable surface,
reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
Only trained service technicians are authorized to remove the system
Troubleshooting Your System
179