Removing A Hard Drive Or Other Device From A Removable Media Bay - Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual

Removing a Hard Drive or Other Device from a
Removable Media Bay
To remove a device from a removable media bay:
1. Follow the steps in "Removing the Access Panel" at the beginning of
this chapter.
2. Disconnect the power and data cables from the back of the device.
3. Remove the screws on each side of the device
the device out from the front of the chassis
Figure 3-13. Removing a device from the removable media bay
4. Install another device or a drive tray. Replace the bezel blank (or blanks)
if no device is installed. See "Removing Bezel Blanks" and "Removing
a Drive Tray" earlier in this chapter.
5. Replace the access panel and the front bezel.
6. Restore power to the server.
Hardware Options Installation 3-17
, and then gently slide


.

2
1
1