Separation Pressure Lever Position - Ricoh Priport DX 3343 Operating Instructions Manual

Basics
When printing onto thin paper
A Set the side pads to both sides
of the paper feed side plates.
Make sure that the paper feed
side plates touch the paper
lightly.
2
D
Shift the lock lever to its original
position.
E
When you finish printing, shift
the feed roller pressure lever to
the Standard paper position.
34
Separation Pressure Lever
Position
A
To prevent double feed, adjust the
paper separation pressure using
the separation pressure lever.
Note
❒ Paper separation pressure can
be adjusted according to the pa-
per weights as shown in the fol-
lowing table.
Position
1
TSLY015E
*1
2
3
*1
This position can also be used if
the leading edge of the paper is
curled, or when the paper does
not feed properly.
ANT075S
ANT117S
Metric Inch
version version
Use this position if the
leading edge of the pa-
per is curled, or when
the paper does not feed
properly at Position 2.
81.6–209.4 21.7–55.6
2 lb.
g/m
47.1–81.5 12.6–21.6
2 lb.
g/m