Installing The Control Panel Assembly; Sas Backplane; Removing The Sas Backplane - Dell PowerEdge T310 Hardware Owner's Manual

Installing the Control Panel Assembly

1 Push the control panel gently into the chassis
2 Connect the control panel cable to the control panel board.
3 Using a Phillips screwdriver, replace the screw that secures the control
panel assembly to the chassis.
4 Connect the control panel assembly cable to the system board.
See Figure 3-27.
5 Close the system. See "Closing the System" on page 86.
6 Place the system upright on a flat surface.
7 Replace the front bezel. See "Installing the Front Bezel" on page 82.
8 Reattach any peripherals and connect the system to an electrical outlet.
9 Turn on the system and attached peripherals.

SAS Backplane

Removing the SAS Backplane

CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Remove the front bezel. See "Removing the Front Bezel" on page 81.
2 Turn off the system and attached peripherals, and disconnect the
system from the electrical outlet.
3 Open the system. See "Opening the System" on page 85.
CAUTION:
the hard drives from the system before removing the backplane.
CAUTION:
label them before removal so that you can replace them in the same locations.
4 Remove all hard drives. See "Hard Drives" on page 90.
138
Downloaded from www.Manualslib.com
Many repairs may only be done by a certified service technician.
To prevent damage to the drives and backplane, you must remove
You must note the number of each hard drive and temporarily
Installing System Components
manuals search engine