Advertisement
60W RGBW 4IN1 LED ZOOM Par
This product manual contains important information about the safe
installation and use of this projector. Please read and follow these
instructions carefully and keep this manual in a safe place for future
reference.
User manual
Please read the instructions carefully before use
Advertisement
Table of Contents
Related Manuals for RIUKOE Glow Z60 IP
Summary of Contents for RIUKOE Glow Z60 IP
- Page 1 60W RGBW 4IN1 LED ZOOM Par This product manual contains important information about the safe installation and use of this projector. Please read and follow these instructions carefully and keep this manual in a safe place for future reference. User manual Please read the instructions carefully before use...
- Page 2 TABLE OF CONTENTS ...............................................................................................................................................................................
-
Page 3: Preventing Electric Shock
STATEMENT The product has well capability and intact packing when leave factory. All of the user should comply with warning item and manual, any misuse cause of the damages are not included in our guarantee, and also can not be responsible for any malfunction &... -
Page 4: Preventing Burns And Fire
Always power off/unplug the fixture before removing any covers. Ensure that the power is turned off when connecting the fixture to the AC mains supply. Ensure that the fixture is electrically connected to earth (ground). Do not apply power if the fixture is in any way damaged. Preventing burns and fire Install in a location that prevents accidental contact with the fixture. - Page 5 For permanent installation, ensure that the fixture is securely fastened to a load-bearing surface with suitable corrosion-resistant hardware. For temporary installation with clamps, ensure that the quarter-turn fasteners are turned fully and secured with a suitable safety cable. The cable must be approved for a safe working load (SWL) of 10 times the weight of the fixture, and it must have a minimum gauge of 3 mm.
-
Page 6: About Dmx
The fixture is controllable using a DMX control device and it can be connected using a DMX cable. If using a cabled DMX system, connect the DMX in cable (with male 3-pin XLR plug) and out cable (with female 3-pin XLR plug) to the DMX data link. Terminate the DMX out cable of the last fixture in the data link. - Page 7 the DMX start address. Each fixture must have a DMX start address set. For example, if a fixture has a DMX address of 10 and it is in 4-channel DMX mode, then it uses channels 10, 11,12 and 13. The following fixture in the DMX chain could then be set to a DMX address of 14.
- Page 8 0-255 Color Mixing Color choose 0-255 Front 7 channel enable( 0-11); Auto DMX more than 11,corresponding inside program Speed from Fast Slow 0-255 Auto Speed CH10 0-255 From large to small Focus Speed from Fast Slow CH11 0-255 Motor Speed CH12 194-255 Reset...
- Page 9 To go forward in the selected functions DOWN To go backward in the selected functions ENTER To confirm the selected functions Set DMX Address Code Press "Menu" to "Set DMX Address",and press "ENTER" keys to enter into. Show "Set DMX Address DMX Address:001",Press the "UP and DOWN" keys to amended.
-
Page 10: Light Source
Auto test Press Menu to the main Menu. Sound1 Press Menu to the main Menu. Sound2 Press Menu to the main Menu. Sound3 Press Menu to the main Menu. Press Enter to get in ,press up &down to Light Adj STD/slow choose ,then press Enter for ok. - Page 11 Size & Weight: N.W.:5.4kg Dimension size: 319x184x271 mm Packing size: 390x250x250 mm Lux Date:...
Need help?
Do you have a question about the Glow Z60 IP and is the answer not in the manual?
Questions and answers