EMS SmartCell Installation Manual page 3

Part number
SC-61-0002-0001-99
Pre installation
!
©2022 EMS Ltd. All rights reserved.
Installation must conform to applicable local installation
codes and should only be installed by a fully trained competent
person.
The procedures outlined in this installation guide must be
carefully followed.
This device contains electronics that may be susceptible to
damage from Electrostatic Discharge (ESD). Take appropriate
precautions when handling electronic boards.
To ensure correct operation, products must be used within the
specified environmental operating conditions.
This communications module can only be fitted internally
within SmartCell control panels containing backboards with
riser card retaining slots. See page 8.
For previous revisions of SmartCell control panels, the
communications module can be connected externally via serial
connection. A suitable enclosure must be used. Refer to the
SmartCell programming guide (TSD155) for full wiring details.
Page 3 of 16
Product description
Internal communications module (Nano 2)
MK374-0001-99 (Issue 1) 17/08/2022 AJM