EMS fusion FCX-532-001 Installation Manual

Loop Module
Installation Guide
POWER
FAULT
ISOLATOR
ACTIVE
Step 1 Pre Installation
The Fusion Loop Module installation must conform to
!
applicable local installation codes and should only be
installed by a fully trained competent person.
The following points require consideration upon installation:
Loop Module location. Refer to the design drawings generated
from the radio survey.
Radio performance. Refer to step 3 to ensure the radio
performance is optimised.
Remote aerials. If using remote aerials with this product, refer
to the Remote Aerial Installation manual for more information.
A maximum of 5 Loop Modules can be connected per loop.
Step 3 Mounting Location Guidelines
To ensure
optimum range
performance
the Loop Module
is achieved, the following
should be considered:
Ensure the Loop Module is
not installed within 2m of
other radio or electrical
equipment (not including
the Control Panel).
Ensure the Loop Modules
aerials are not installed
within 0.6m of any metal
work.
Step 5 Prepare the Loop Module Back Box
Drill the required
cable entry points
where necessary.
= Do Not Use
= Available Cable
Entry Points
©2014 EMS Radio Fire & Security Systems Ltd. All rights reserved
F usion
F usion
Loop Module
the
2m
of
0.6m
Loop
POWER
Module FAULT
FIRE
Control
Panel
Fire Alarm Control
Part No

Product Description

Fusion Loop Module
FCX-532-001
Fusion Loop Module c/w Remote Aerial Facility
FCX-532-002
Step 2 Loop Module Components
1
2 3
Item No 1
Part Description
4X Corner
covers
Step 4 PCB Removal
POWER
The internal PCB of the Loop Module can be removed to ensure that
FAULT
damage is not caused during installation.
Remove the central retaining screw prior to unclipping the PCB.
ISOLATE
WD
Step 6 Fit Loop Module Back Box to the Wall
Fit the Back Box
to the wall.
All five circled
fixing positions
are available for
use.
1/2
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
4
2 3 4
4x Lid 1x Loop 1x Loop
Screws Module Lid
Module PCB
BACK
LOOP IN LOOP OUT
- -
TSD077 Iss 3c 15/04/14
5
5
1x Loop Module
Back Box
0V
RX
TX
3V
AJM