KwiKool KPHP Series Operation Manual page 8

Hot Make-up Air leads to the KwiKool System trip-
ping its HP Reset switch. If this occurs, HP will ap-
pear on the control panel. To resolve, fix the lack of
Make-up Air and reset the HP Reset switch per the
instructions in Section IX, Troubleshooting
Guide.
L'air chaud d'appoint conduit le système KwiKool à
déclencher son interrupteur de réinitialisation HP.
Si cela se produit, HP apparaîtra sur le panneau de
commande. Pour résoudre le problème, corrigez le
manque d'air d'appoint et réinitialisez le commu-
tateur de réinitialisation HP conformément aux in-
structions de la section IX, Guide de dépannage.
For areas with a closed ceiling or no ceiling use the double flange ceiling kit method or ex-
tended duct method. Visit www.KwiKool.com for more information and a complete set up
guide.
H. POWER CONNECTION
Verify the source power, phase and breaker size is compatible with the unit's serial plate in-
formation. The electrical circuit is dedicated only for the use of the KwiKool System. If in
doubt, contact a licensed electrician. The KwiKool System comes from the factory with eight
feet of power cable sized to fit the electrical specification of the unit's electrical requirement.
• An extension power cable is allowed, but cannot exceed 25 feet and must be rated to op-
erate the KwiKool System.
KwiKool Systems that come supplied with a factory-installed plug require the exact recep-
•
tacle to match the plug and exact circuit-size and power.
Cutting the power plug on the KPHP unit will void
its warranty.
Couper la fiche d'alimentation de l'unité KPHP an-
nulera sa garantie.
CAUTION
PRUDENCE
CAUTION
PRUDENCE
8