User Parameters - KwiKool KPHP Series Operation Manual

SECTION IX - USER PARAMETERS
Entrance into this function is gained by a 3-second press on the SETTINGS button. Another
short press on this button changes the temperature display to C or F. Use the FAN and Mode
buttons to scroll through the different settings while in User Parameters.
Select ON/OFF to exit or after 1 minute the display will default back to the operating screen.
USER PARAMETERS LIST
P30 turns the sound that indicates a button is pressed on the display screen off or on. Use
the UP or DOWN arrow buttons to choose 0= no sound. 1= sound
P40 displays the remaining time until filter maintenance is required in 1-day intervals. This is
Read Only. Not adjustable by user.
P41 Allows reset of the filter counter and alarm by choosing 1 (UP Arrow). Select 0 for normal
operations without resetting. Always defaults back to 0 after reset.
P42 sets the Filter Alarm Delay Time in days. Use the UP and DOWN arrows to set how long
(in days) until the alarm displays after the filter counter time (shown in P40) elapses.
P100 enables the user adjusted dimming control for the display. 0=Inactive, 1 Active.
P101 adjusts how long the display will stay bright in active mode before it dims to inactive, in
seconds. The minimum is 30 seconds. 0=30 seconds up to 99 seconds.
P102 adjusts how bright the dim setting is in terms of percent of full brightness.
P105 adjusts how bright the bright setting is in terms of percent of full brightness during the
active mode.
P201 displays the microprocessor board version.
P30- Beeper enable
P40-Filter counter
P41-Filter counter reset
P42-Filter Alarm Delay
P100- Enable Dimming
P101-Dimming time
P102Dimming brightness
P105-Brightness in active
state
P201-Microprocessor
Board version
User Parameters Table
Select 0 or 1
Hours/10- 0 thru 999
Select 1 to reset
Days, select 0 thru 180
Select 0 or 1
Min, Select 0 through 10
% 1,5,10 through 90
% 50 through 100
N/A
23
0- Disable, 1-enable
Read Only
Defaults back to 0
0- Disable
0-Disable, 1 Enable
Defaults to 5
Defaults to 10
Defaults to 100
N/A