Table of Contents
Advertisement
Adjusting PHASE
This adjustment corrects the phase of convergence wave forms.
NOTE: Since the projector has been pre-adjusted for the
optimal phase adjustments at the factory, further adjustment
should not be required in normal operation. In some cases,
carrying this adjustment causes convergence to change.
1) Select "10/PHASE" and press ENTER to display the phase
adjustment screen.
• The CROSS-COARSE test pattern will be automatically
displayed and the adjustments will be cancelled. You can
also display the adjustment screen by pressing PHASE
button on the service remote control.
2) Use the CURSOR
or
phase (for horizontal line). Adjust the pattern so the sharp
turns at the left and right edges in the diagonal lines are equal.
3) Use the CURSOR
or
(for vertical line).
Align the vertical center line of the point cursor with the
point peak.
button to adjust the convergence
button to adjust the cursor phase
P H A S E
- C O N V . , C U R S O R -
CON
C N
CUR
C U
55
ADJUSTMENT
2 0 %
2 0 %
Advertisement
Table of Contents
