Address Setting - NEC XG85-XG135LC - 1 Manual

Address Setting

Each projector needs its own unique address in the case of a serial
connection of projectors. Up to 64 addresses can be set.
Proceed as follows:
1 Press the ADJUST button to display the "ADJUST" menu.
• The projector may ask you to enter your passcode.
See page 61 for the explanation of the PASSCODE.
2 Use the CURSOR or
line. Press ENTER to display the "OPTION" menu. You can also
select the "OPTION" menu directly by pressing the INPUT "8"
button.
3 Use the CURSOR or
DRESS" line. Press ENTER to display the "ADDRESS" screen.
You can also select the "ADDRESS" menu directly by pressing
the INPUT "4" button or the ADDRESS button on the full
function remote control.
4 Enter the address number using the INPUT button and press
ENTER.
• If you have made a mistake, press END to return to the "OP-
TION" menu, then start again.
NOTE: Enter the address number "01" when only one projector
is used.
button to highlight the "8/OPTION"
button to highlight the "4/PJ AD-
– A D J U S T –
1 / S I G N A L E N T R Y
2 / F O C U S
3 / A L I G N M E N T
4 / C O N V E R G E N C E
5 / K E L V I N
6 / R , G , B G A I N
7 / P A S S C O D E
8 / O P T I O N
9 / R E F . A D J U S T
– O P T I O N –
1 / S E T T I N G M O D E
2 / M E N U M O D E
3 / S E Q U E N C E R
4 / P J A D D R E S S
5 / V E R S I O N
6 / H O U R M E T E R
7 / D E F A U L T D A T A
117
O P T I O N
- P J A D D R E S S -
0 1 ( 0 1 - 6 4 )
SETTING