Table of Contents
Advertisement
SETTING
Selecting "P-ON"
1) Use the CURSOR or
ENTER.
• The POWER ON input screen will be displayed.
2) Enter the POWER ON TIME you wish to turn on the projec-
tor using INPUT buttons and press ENTER.
• Type the time in hours (24 hours), minutes and seconds.
• If you made an error, press END to return to the Program
menu, then start again.
NOTE 1:
Typing 99:99:99 in the time input menu will execute
the program immediately.
NOTE 2:
The P-ON command is available only when the
projector is off (in the standby condition).
The P-ON command is ignored if set in the first line. In this
case, the program will start its execution from the second line.
Selecting "P-OFF"
1) Use the CURSOR or
ENTER.
• The POWER OFF input screen will be displayed.
2) Enter the POWER OFF TIME you wish to turn on the
projector using INPUT buttons and press ENTER.
• Type the time in hours (24 hours), minutes and seconds.
• If you made an error, press END to return to the Program
menu, then start again.
NOTE:
Typing 99:99:99 in the time input menu will execute the
program immediately. (See the example in the "WAIT" section
on page 108)
button to select "P-ON" and press
button to select "P-OFF" and press
114
I N P U T
W A I T
G O T O
L O O P
P - O N
P - O F F
I N S E R T
D E L E T E
T I M E _ _ : _ _ : _ _
I N P U T
W A I T
G O T O
L O O P
P - O N
P - O F F
I N S E R T
D E L E T E
T I M E _ _ : _ _ : _ _
Advertisement
Table of Contents
