Advertisement
direct memory access (DMA) channels, and input/output (I/O) addresses. See the following procedures to
view system resources.
Follow these steps to view system resources:
From the Windows 95 desktop, click the "My Computer" icon with the right mouse button.
Click "Properties." The System Properties box appears.
Click the Device Manager tab.
Double click "Computer." The Computer Properties box appears and displays the View Resources folder.
The View Resources folder shows the system resources used by your computer. For example, it shows a list
of interrupts and how they are allocated. If an interrupt is not in the list, it is available.
Checking Jumper Settings
The following procedure explains how to locate and, if necessary, change jumper settings when upgrading the
processor. See this section to also view factory jumper settings.
CAUTION: Jumpers are set correctly at the factor. If the system requires a jumper change, change only the
setting for that condition. Otherwise, keep the settings at their factory settings.
WARNING: The system power must be off before changing a jumper setting.
Power off and unplug the system and any attached devices.
Remove the system cover (see Section 3, "Removing the Cover").
Locate the processor host bus frequency jumper (J9C1-C), and processor frequency jumper (J9C1-D) on the
system board (see Figure C-1).
If required, remove any installed expansion boards to access the jumpers (see Section 3, "Expansion Board
Removal").
Advertisement
