Advertisement
Slide the 3 1/2-inch diskette drive out of its slot in the front of the system unit.
Figure 5-11 Locating the Diskette Drive Screws
Power Supply Removal
Remove the power supply as follows.
Remove the system unit cover as previously described.
Remove the two screws securing the power-on switch and cable to the front of the system unit, free the switch
from the system unit, and let it dangle out-of-the-way while removing the power supply.
Figure 5-12 Locating the Power-On Switch Screws
Unplug the two power cables attached to the system board connectors.
Unplug the power cables from all installed devices.
Cut any tie wraps that may be securing the power cables to the system unit.
Advertisement
