Advertisement
System Unit Cover Removal
To remove and replace the system unit cover, use "Removing the Cover" in Section 3.
NOTE: Unplug the power cord before disassembling the system unit. Voltage is present inside the system unit
even after the power is off. All voltage is removed only when the power cord is unplugged.
Expansion Board Removal
Remove any installed expansion board(s) per the following steps.
Remove the system unit cover as previously described.
Disconnect any cables leading from the expansion board(s).
Remove the screw from the expansion slot bracket (see Figure 5-1).
Remove the expansion board.
Figure -1 Removing the Expansion Board
Front Panel Removal
Remove the front panel from the chassis as follows.
Remove the system unit cover as previously described.
The front panel is secured with six metal plugs. Remove the front panel by evenly pulling the panel from the
chassis (see Figure 5-2).
Advertisement
