Advertisement
Figure -7 Locating the Suspend Switch
DIMM Removal
Remove any optional DIMMs from the system board as follows.
Remove the system unit cover.
Locate the DIMM sockets.
To remove a DIMM from its socket, press the plastic clips at the outer edges of the socket away from the
DIMM.
Carefully rock the DIMM to pull it from the socket.
Figure -8 Removing a DIMM
5 1/4-Inch Device Removal
Remove a 5 1/4-inch device from the system unit as follows.
Remove the system unit cover and front panel as previously described.
Label and unplug all signal and power cables from any device(s) in the 5 1/4-inch device cage. Also unplug
the audio cable from the CD ROM reader.
If removing a device from the top 5 1/4-inch slot, remove the two screws securing the left side panel to the
system unit, tilt the panel out slightly and then lift it away from the system unit. Next remove the system board
(See "System Board Removal" later in this section.) Then remove the four screws, two to a side, securing the
device to the system unit (see Figure 5-9).
NOTE: When removing a device from the top 5 1/4-inch slot, the left side panel and the system board must
be removed to access one of the two screws on the left side of the device.
Advertisement
