Icom IC-24AT Instruction Manual page 32

(2) SCAN RESUME CONDITION mm POWER ON
2 resume conditions are available: pause and timer scan.
When receiving a signal, pause scan pauses (800 th ‫تنے‬‎
disappears; timer scan pauses for approx. 10 sec.
RI
* While holding the following switches, turn ON power to
change ihe condition.
- [4] + [LIGHT] : Pause scan
eta pauses until signal disappears.)
- [5] + [LIGHT]: Timer scan (Scan pauses for 10 sec.)
(3) FREQUENCY SKIP FUNCTION
1) Start full scan or programmed scan.
(p. 28).
ee Section 10-2
2) To program tne received frequency as a skip frequency:
- When scan pauses, push and hoid [B] (MR/MW) while
pushing [FUNC] until ihe transceiver emits 3 beeps.
a Memory channel number 39 appears for a moment.
9 The channel number decreases when programming tne
next frequency. Memory channels 39 — 20 can be used
for programming.
10 SCAN OPERATION
usne SEI MODE
(1) SETTING THE
PROGRAMMED SCAN EDGES
Both VHF and UHF bands have two independent scan edges
for each band.
Scan edge frequency B. Scan edge frequency A.
1) Push [A] (CLR) to select VFO mode.
2) Push [C] (V/U) to select the desired operating band, VHF
or UHF.
3) While pushing [FUNC], push [8] (SET) to enter SET mode.
e Refer to p. 8 for SET mode details.
4) Push [x]( v) or [3 ]( ^) severa! times until "PA" appears
as shown above.
5) Set one scan edge frequency using the Keyboard or tun-
ing control.
6) Push [ ]( A) ("PB" appears), then set the other scan edge
frequency.
7) Push [A] (CLR) or [PTT] to set values and to exit SET mode.