Icom IC-24AT Instruction Manual page 28

8-3 Programming a cai
channel
The call channel contenis can be programmed in a similar
way as the memory channels.
Push and hold
5 MR/MW H
God + ¿ED | 32.4 E :
>! LJ "am. |
VFO moda.
2) Set the desired frequency (and duplex, when required) to
be programmed into tne call channsi on the main or sub
irequency display.
Push [D] (CALL) to cali up ihe call channel, then selsct
a bend using [C] (V/U) when required.
LA
‫ي‬ ‫و‬ ‫د‬ ‎
| While pushing [FUNC], push and hold [5] (MR/MY) until
ine transceiver emits 3 beeps.
o The displayed frequency is changed to the same as ine
VFO frequency (same as the selscied call channel).
A
VHF VFO MODE
x
CALL/LOCK
V/U/SPLIT
VHF CALL CHANNEL UHF CALL CHANNEL
1) Push [D] (CALL) to call up a call channel.
2) Push [C] (W/U) to change the band when required.
3) To return to the previous mode, push [D] (CALL) again.
8-2 Transferring
channel
2) While pushing [FUNC], push and hold [A] (CLR/M >V) until `
the transceiver emits 3 beeps to transfer the contents into
the VFO.
o VFO mode is automatically selected.