Icom IC-24AT Instruction Manual page 25

MEMORY OPERATION 7
memory
e 40 memory channels is double-spaced. When
‫م‬ ‫ر‬ ‎ y is programmed into each space, you can
operate on 80 cnannels.
(D WRITING
1) Select the memory channel to be programmed, then push
iA] (CLR) to select VFO mode.
EE Vi 3 and UHF frequencies on ihe main and sub
NM
Mars?
3) While pushing [FUNC], push [C] (V/U/SPLIT).
"SPT" appears.
o Ori
FUNC], push [B] (MR/MW) until the
4) While dup. 1 ۱
lis 3 58205 to store the information.
transceiver em
(2 USING AS SIMPLEX
) Select a memory channel programmed with dual band
frequencies.
ch
2) Pusn [C] (V/U) to move the desired frequency on the
3) While pushing [FUNC], push [C] (V/U/SPLIT) to set
simplex.
ə "SPT" disappears, but the crossband full duplex function
still remains in the memory channel.
Select the memory nene to De programmed.
a See Section 7-1 for detail
١ Push [A] (CLR) to select VFO mode.
d, , program
1 55s ater information, |
cr full duplex informal! Gs see rignt (1
NAVY) until
the transceiver emits 3 beens.
nto ine memory channel and ni
you wani to check ine contents, push [B] (MR).
1)
5) While pushing [FUNC], push and hold [B] (MR/
8) After the frequency is written
MOTE: Repeater information is automatically written
duplex information is |
into a memory except when full
written specially.
Each memory channel can separately store tone fre-
quency, tone ON/OFF and *tone squelch ON/OFF, when
the optional UT-50 or UT-51 are installed.
* UT-50 only