SMC Networks ES4704BD Manual page 506

the public non-backbone area. The protocol treat routers connected by virtual links as a
point-to-point network
Example:
Switch#config terminal
Switch(config) #router ipv6 ospf
Switch(config-router) #area 1 virtual-link 10.10.11.50 hello 5 dead 20
Switch(config-router) #area 1 virtual-link 10.10.11.50 instance-id 1
14.7.3.5 abr-type
Command: abr-type {cisco|ibm| standard}
no abr-type [cisco|ibm| standard]
Function: Configure an OSPF ABR type with this command. The "no abr-type
[cisco|ibm| standard]" command restores the default
Parameter: cisco, realize by cisco ABR; ibm, realize by ibm ABR; shortcut, specify a
shortcut-ABR; standard, realize with standard（RFC2328）ABR.
Default: Cisco configured by default
Command Mode: OSPFv3 protocol mode
Usage Guide: For Specifying the realizing type of abr. This command is good for
interactive operation among different OSPF realizing method and is especially useful in
the multiple host environment.
Example: Configure abr as standard
Switch#config terminal
Switch(config)#router ipv6 ospf
Switch(config-router)#abr-type standard
14.7.3.6 default-metric
Command: default-metric <value>
no default-metric
Function: The command set the default metric value of OSPF routing protocol; the "no
default-metric" returns to the default state.
Parameter: <value>, metric value, ranging between 0~16777214
Default: Built-in, metric value auto translating
Command Mode: OSPF protocol mode
Usage Guide: When the default metric value makes the metric value not compatible, the
route introducing still goes through. If the metric value can not be translated, the default
value provides alternative option to carry the route introducing on. This command will
result in that all introduced route will use the same metric value. This command should be
used associating redistribute.
506