SMC Networks ES4704BD Manual page 336

allowed.
Command Mode: DHCP Address Pool Mode
Usage Guide: Specify the name of the file to be imported for the client. This is usually
used for diskless workstations that need to download a configuration file from the server
on boot up. This command is together with the "next sever".
Example: The path and filename for the file to be imported is "c:\temp\nos.img"
Switch(dhcp-1-config)#bootfile c:\temp\nos.img
11.2.2.2 client-identifier
Command:client-identifier <unique-identifier>
no client-identifier
Function: Specifies the unique ID of the user when binding an address manually; the "no
client-identifier" command deletes the identifier.
Parameters: <unique-identifier> is the user identifier, in dotted Hex format.
Command Mode: DHCP Address Pool Mode
Usage Guide: This command is used with "host" when binding an address manually. If
the requesting client identifier matches the specified identifier, DHCP server assigns the
IP address defined in "host" command to the client.
Example: Specifying the IP address 10.1.128.160 to be bound to user with the unique id
of 00-10-5a-60-af-12 in manual address binding.
Switch(dhcp-1-config)#client-identifier 00-10-5a-60-af-12
Switch(dhcp-1-config)#host 10.1.128.160 24
11.2.2.3 client-name
Command:client-name <name>
no client-name
Function:Specifies the username when binding addresses manually; the "no
client-name" command deletes the username.
Parameters: <name> is the name of the user, up to 255 characters are allowed.
Command Mode: DHCP Address Pool Mode
Usage Guide: Configure a username for the manual binding device, domain should not
be included when configuring username.
Example: Giving the user, with unique id of 00-10-5a-60-af-12, a username of "network".
Switch(dhcp-1-config)#client-name network
11.2.2.4 default-router
Command:default-router <address1>[<address2>[...<address8>]]
no default-router
Function: Configures default gateway(s) for DHCP clients; the "no default-router"
336