Menu Item Service - Pepperl+Fuchs MWC25M-L2M-B20 Series Manual

MWC25M-L2M-B20 series
Parameterization and Analysis Using PACTware and DTM via J1939
7.5

Menu Item Service

Figure 7.13
In the Service menu item, you can restore the sensor to its factory settings.
Clicking the "Reset to factory defaults" button will restore the sensor to its factory settings. All
previous parameter changes are lost as a result. After the voltage supply has been switched off
and on again (power cycle), the sensor re-initializes on the bus with its factory defaults.
Note
The baud rate and operating hours are not restored to the factory settings.
Use the "Product Website" button to go to the product area information page (landing page) for
the MWC25M-L2M-B20 series.
42