Table of Contents
Advertisement
PCs with 10/100/1000Mbps Ethernet cards: Your PC must
have a standard Ethernet interface to connect to the switch.
UTP cable with RJ-45 connector: Check if the cable and
connectors work properly.
Fiber cable with SC/ST/MT-RJ/VF-45 connector: Check if the
cable and connector types are correct.
A power outlet: 100 to 240V AC at 50 to 60 Hz. Make sure that
the switch power is accessible and cables can be connected
easily.
Dedicated power supply: Use dedicated power circuits or
power conditioners to supply reliable electrical power to the
network devices.
A dry cool place: Keep the switch away from moisture. Avoid
direct sunlight, heat source, and high amount of electromagnetic
interference around.
Mounting tools: If you intend to mount the switch on a rack,
make sure you have all the tools, mounting brackets, screws.
Mounting the Switch
The Modular Switch is suitable for use in an office environment
where it can be rack-mounted in standard EIA 19-inch racks or
standalone.
Desktop Installation
Set the Switch on a sufficiently large flat space with a power outlet
nearby. The surface where you put your Switch should be clean,
smooth, level, and sturdy.
Make sure there is enough clearance around the Switch to allow
attachment of cables, power cord and air circulation.
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the Switch is
grease and dust free.
21
Advertisement
Table of Contents
