Connecting The Switch - SMC Networks 6704FMSC Installation Manual

Power On
After all network cables are connected, plug the power cord into the
power socket on the back panel and the other end into a power
outlet. Turn the power on using the power switch on the back panel.
Check the front panel Power indicator to see if power is properly
supplied. The switch uses a universal power supply that requires no
additional adjustment.
Diagnostic Test
After the installation is completed and AC power is applied to the
switch, the system will automatically perform a diagnostic test.
When the Power LED is on within 5 seconds, the Diagnostic status
LEDs will soon flash red.
When the switch passes the self-test within 10 seconds, the
Link/ACT LED turns on.
If the switch fails the self-test, the Diagnostic LED will blink.

Connecting the Switch

The serial console port is a male DB-9 connector that enables a
connection to a PC or terminal for monitoring and configuring the
switch.
Use the supplied RS-232 cable with a female DB-9 connector to
connect a terminal or PC to the console port. The terminal or PC to
be connected must support the terminal emulation program.
24