SMC Networks 6624FMSC - annexe 1 Installation Manual page 41

Here is some information on the fields in the Setup screen. For more informa-
tion on these fields, see the Management Guide that came with your switch:
Parameter Default
System Name blank
System Contact blank
Manager Password blank
Logon Default CLI
Time Zone 0 (none)
Community Name public
Spanning Tree Enabled No
Default Gateway blank
TimeP Config DHCP
IP Config (DHCP/Bootp) DHCP/Bootp
IP Address xxx.xxx.xxx.xxx Recommended; If you set IP Config to Manual, then enter an IP address
Note: The IP address and subnet mask assigned for the switch must be compatible with the IP addressing used in
your network. For more information on IP addressing, see the Management Guide that came with your switch.
Subnet Mask xxx.xxx.xxx.xxx Recommended; If you entered an IP address, then enter a subnet mask
The switch is now configured with a Manager password, IP address, and
subnet mask, and can be accessed through your network using Telnet, the web
browser interface, or an SNMP-based network management tool such as
EliteView.
To Recover from a Lost Manager Password: If you cannot start a con-
sole session at the manager level because of a lost Manager password, you
can clear all passwords and user names by getting physical access to the
switch and pressing and holding the Clear button for a full second.
Optional; up to 25 characters, including spaces
Optional; up to 48 characters, including spaces
Recommended; up to 16 characters (no blank spaces)
The default setting selects the command line interface for console access.
The alternative is the menu interface.
Optional; 1440 to -1440. The number of minutes your location is to the West
(+) or East (-) of GMT.
Default setting recommended.
Default setting recommended unless STP is already running on your network
or the switch will be used in complex network topologies.
Optional; Enter the IP address of the next-hop gateway node if network traffic
needs to be able to reach off-subnet destinations.
Optional; The method the switch uses to acquire the TimeP server address.
Set to Manual unless a DHCP/Bootp server is used on your network to
configure IP addressing.
compatible with your network.
compatible with your network.
Installing the SMC6624M Switch
Getting Started With Switch Configuration
2-19