Omtech LYF-20MP User Manual page 8

1 Safety Information
1.3 Safety Instruction Labels
Your engraver should come with instruction labels in the following locations. For specific details
of the nameplate, see the nameplate attached to the machine. If any of these labels is missing,
illegible, or damaged, it must be replaced.
Typ
ф
λ
1.4 General Safety Instructions
• DO NOT leave this machine unattended during operation. Observe the machine throughout
the operation and, if anything seems to be operating strangely, immediately cut off ALL
power to the machine and contact either our customer service or your dedicated repair
service. Similarly, ensure the machine is FULLY turned off (including using the emergency
stop switch) after each use.
• DO NOT allow minors, untrained personnel, or personnel suffering from physical or mental
impairment that would affect their ability to follow this manual and the software manual to
install, operate, maintain, or repair this machine.
• ALWAYS keep a fire extinguisher or other flame-retardant system nearby in case of
accidents. Ensure that the local fire department's phone number is displayed nearby. In the
case of a fire, cut electrical power BEFORE dousing the flame. Familiarize yourself with the
correct range for your extinguisher BEFORE use. Take care not to use the extinguisher too
close to the flame, as its high pressure can produce blowback.
3