Omtech LYF-20MP User Manual page 43

5.3.2 Instructions for EZCad
Click Laser → Rotate TextMark in EZCad to check and make sure the rotary settings are the
1.
same as that on the picture "Laser-Rotate TextMark-param.jpg" on the USB drive.
2. Set other rotary parameters.
For detailed instructions, see the EZCad software manual.
3. Prepare your design, test and engrave.
For detailed instructions, see
Engraving Effect (Page
§5.2.3 Preparing Your Design
§5.2.6 Engraving
34), (Page
38
OK Cancel Apply
(Page 30),
35).
§5.2.4 Testing the