BRONKHORST FLEXI-FLOW Compact Instruction Manual page 12

The documents listed in the following table can be downloaded from www.bronkhorst.com/downloads.
Type
Manuals
Compliance
*) Note that the FLEXI-FLOW has no RS-232 communication interface. The RS-232 manual provides useful information about the
ProPar protocol.
1.7 Safety notes
Please read this document entirely and carefully before installing and operating the product. Not following the
guidelines could result in personal injury and damage to the product and the system(s) it is incorporated in or
connected with.
The product(s) described in this document may only be handled by qualified personnel who are familiar with
·
combined fluid and electrical systems and who recognize the associated hazards (e.g. (high) fluid pressure, electric
shock).
The user is responsible for taking the necessary safety measures to prevent damage and/or injury while working
·
with the equipment and process media (as described in the associated Material Safety Data Sheets).
· Where appropriate, this document recommends or prescribes safety measures to be taken with respect to media
or equipment usage under the specified conditions. However, this does not relieve the user of aforementioned
responsibility, not even if such is not explicitly recommended or prescribed in this document.
· The equipment and its accessories must be used in accordance with their specifications and intended use.
The customer is responsible for conducting a risk analysis for the entire system and take the required safety
·
precautions, following applicable laws and regulations. Based on the risk analysis, the customer should describe
and adhere to standard operating procedures to ensure safe use of the equipment.
Individual instruments may not be disassembled or modified in any way or for any purpose.
·
· Unauthorized modifications to the product can undo safety features, compromise system specifications and cause
failure to comply with applicable laws, regulations and directives. Any modification that is not authorized by the
manufacturer of the product, will therefore be considered as
and cancel the manufacturer's liability.
If the product is defective or otherwise does not meet your requirements, please contact your Bronkhorst
·
representative for assistance or advice.
Product related safety warnings
Before operating the FLEXI-FLOW, make sure that the equipment has been installed and configured by an authorized
engineer and that the installation is approved for use.
To ensure and maintain a safe working area, regularly inspect electrical and fluid lines and connections:
· Prior to each use, check cabling for proper connection, damage and wear. If necessary, replace cables and/or
connectors.
· Before, during and after operation, check fluid lines and connections for leaks, damage and wear. If necessary, re-
tighten or replace fluid connectors.
12
Bronkhorst®
Document name
Manual EtherCAT® interface
Manual EtherNet/IP™ interface
Manual FLOW-BUS interface
Manual Modbus interface (RTU & TCP)
Manual POWERLINK interface
Manual PROFINET interface
Manual RS-232 interface*
EU Declaration of Conformity FLEXI-FLOW
EU Declaration of Conformity RoHS
Manufacturer Declaration REACH
Manufacturer Declaration WEEE
Conflict Minerals Compliance Policy
Instruction Manual FLEXI-FLOW™ Compact
unintended and improper use
Document no.
9.17.063
9.17.132
9.17.024
9.17.035
9.17.142
9.17.095
9.17.027
9.06.132
9.06.124
9.06.056
9.06.128
9.06.065
, will void warranty
7
9.17.158G