Finishing-Up - Omtech LYF-175S User Manual

5.2.7 Finishing-up

When you have finished engraving your design, deactivate the systems as follows:
1. Close the EZCad software and disconnect your computer.
2. Turn off the laser marking machine from bottom to top in order:
a. Press the LASER button to turn off the
fiber laser source.
b. Turn the GALVO access key to turn off the
galvo head.
c. Push down the emergency stop button to
turn off the mainboard.
Again, wait about 3 seconds between
each step to allow each system to safely
disengage.
3. Fully clean the workbed. Check the lenses for any accumulation of dust and safely clean them
as well if needed.
4. Cover the galvo lens cap.
5. For best results, disconnect your marking machine from its power supply between uses. Unplug
it or turn off its intermediary surge protector.
42
Emergency
Stop
Galvo
Laser