5.2.3 Preparing Your Design
1.
Make sure the control computer is connected to the machine via the USB cable.
If you previously disconnected the control computer, reconnect it via the USB cable now.
If your computer is already connected and EZCad is already running, restart it now to establish
a connection between the computer and the laser's control board.
2. Double click EzCad2.exe in the "Software" folder in the USB
drive to start the software.
3. Load or create a design in EZCad as follows.
Here we only provide a brief introduction on drawing bitmap pictures and vector graphics and
creating text. For detailed parameter descriptions and settings, see the EZCad software manual
in the USB drive.
Focus Length
36
Need help?
Do you have a question about the LYF-175S and is the answer not in the manual?