Starting Work - Virutex PEB ZeroLine Operating Instructions Manual

Fig. 14
Fig. 15
Fig. 16
Fig. 17
9.2.2. Working speed
To select the working speed, press the switch on the handle
(Fig. 14) and then adjust the desired speed by turning the speed
control dial to the desired value. Once determined, press the
dial to set the speed value (Fig. 15).
The selected speed will be displayed on the control display.
Press the handle button again to put the machine in standby
mode until the edge banding process begins.
9.3. INSERTION OF THE EDGE TAPE
Once the edge banding tape is positioned on the entry guide
and adjusted to the desired height, press the edge feed button
to perform a quick introduction of it (Fig. 16). A programmed
movement moves the edge banding tape and positions it prior
to the edge banding work.

9.4. STARTING WORK

With the green set temperature indicator illuminated, you
can proceed to start the edge banding work by pressing the
handle switch, which will move the edge for activation and
bring the machine closer to the panel for the desired edge
banding. (Fig. 17)
PEB Zeroline® - 21