ITech IT6800AB User Manual page 28

EXIT
POWER
MODEL
INFO
VER
SN-1
SN-2
SN-3
EXIT
EXIT
Quit menu
MENU
说明
NOTE
Press
Maximum voltage (>MAX VOLT)
The maximum voltage can be adjusted from 0A to maximum rated voltage of
each model.
To set max volt:
Press
VOLT item and press
cursor position and set max voltage.Output voltage set will be limited within the
range of max voltage.
MAX VOLT default set is the rated voltage of each model.
OCP Function (>OCP) (Only for IT6800B series)
You can set the OCP point. When the circuit current exceeds the set point,the
OCP function will be enabled. At the same time, the output of power supply will
be OFF and the buzzer will warn. The "prot" remark will be lighted and "OCP"
will appear on the VFD.
When the setting current is over than the OCP current,the testing instrument
will be protected.When the setting current is less than the OCP current, the
circuit current will be limited to the setting current for protection.
OCP current setting operation:
1. Press
2. Press
3. Press
confirm.
4. Press numeric keys to set OCP current, press
Esc
Power up setting (>P-MEM)
P-MEM item is used to set operation parameters state of power supply after
power up.
If select RESET, means to initialize output parameters to factory default setup.
Quit list menu
Model information
Firmware version
First six number of SN
Middle six number of SN
Last six number of SN
Quit information menu
Esc
button can help to quit Menu setup and any function button operation.
I-set I-set
(Shift) +
Enter
(Shift) + I-set I-set
to choose OCP SET, press
to select ON, the OCP function will be ON.press
to escape menu operation.
Copyright © Itech Electronic Co., Ltd.
www.tehencom.com
location
(Menu) button to enter menu setup, scroll to >MAX
to confirm.Using
(Menu) into menu operation.
Enter
Functions and Characteristics
button to adjust
to confirm.
Enter
Enter
to confirm. Press
to
20