Gossen MetraWatt METRA HIT MULTICAL Operating Instructions Manual page 24

Control Functions
During Recording
In order to be able to observe measured values during recording,
switch to the measuring function by pressing
MEAS / CAL | SETUP. After pressing MEAS / CAL | SETUP once again,
the display is returned to the 1nfo menu where memory
occupancy can be queried with the 0CuPP parameter.

Note
As soon as memory is full, the "Store" segment is cleared
from the display.
A new memory block is created when another measuring function
is selected with the rotary switch or the OUT | ENTER key. Data stor-
age then continues automatically.
Ending Recording
OUT OUT
store stop
ENTER ENTER
➭ Press MEAS / CAL | SETUP in order to return to the measuring
function.
➭ Memory mode operation can also be exited by switching the
multimeter off.
24
store
Querying Memory Occupancy
Memory occupancy can be queried during recording with the
help of the "1nFo" menu (see also section 7.3).
Memory occupancy range: 000.1% to 099.9%.
MEAS / CAL OUT
bAtt:  ...  0CCvP %: 017.4 %
1nFo
SETUP ENTER
Memory occupancy can be queried before recording is started via
the "1nfo" menu.
MEAS / CAL
1nFo   StorE
...
SETUP
Clear Memory
This function deletes all measured values from memory! This
function cannot be executed during memory mode operation.
MEAS / CAL
1nFo   StorE
...
SETUP
OUT
empty  StorE
ENTER
OUT
017.4 %  StArt
ENTER
OUT
StArt  Clear  yes
ENTER
GMC-I Messtechnik GmbH