Intelligent Weighing Technology IDC-12 Service Manual page 9

4. OPERATION
Initial Start-up
Warm-up time of 15 minutes stabilizes the measured values after switching on.
1. Power ON/OFF
Power switch is located below the right side of the scale. Switch on the scale by
pressing on/off. The display is switched on and the self test is started.
If you want to switch off press backward the key.
2. Switch to Local / Remote Scale
 By pressing
In Local Scale
In Remote Scale
 The basic weighing functions are same for both the scales- local and remote.
 The number of weighing divisions may be less on the remote scale dependant
on the total capacity of the load cell/s used.
3. Zero
Environmental conditions can lead to the balance exactly zero in spite
of the pan not taking any strain. However, you can set the display of
your balance to zero any time by pressing
ensure that the weighing starts at zero.
4. Tare
The weight of any container can be tared by pressing
subsequent weighing the net weight of the object being weighed is always
displayed.

Load weight on the pan.

Press

Remove weight from the platform. Tared weight is displayed. It can
set only one tare value. It can display with a minus value.

Press
Enter a tare value using by numeric keys.
This method allows you to enter a value for the tare weight from the
keypad. This is useful if all containers are the same or if the container is
already full but the net weight is required and the weight of the container is
the display changes from one to other scale.
key. Zero is displayed, and tare is subtracted.
key. Zero is displayed, tare weight is cleared.
change Local
change remote
key and therefore
button so that with
- 9 -