Related Manuals for XtremepowerUS 75171
Summary of Contents for XtremepowerUS 75171
- Page 2 Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in injury and/or property damage. Save all warnings and instructions for future reference. The warning and safety instructions in this manual are not meant to cover all possible conditions and situations that may occur. Common sense, caution and care must be exercised when operating or cleaning tools and equipment.
- Page 3 PUMP PLACEMENT Install the pump in a horizontal ground. The ground must be solid sturdy, horizontal, and no vibration. For the purpose of periodic maintenance, please do not move the pump as far as possible once installation finished. The pump should be used indoors. In order to protect the electrical components from influence of weather, rain loose and a well drainage area are required when used outdoors, so that water will not be stored on rainy day.
- Page 4 OPERATING THE CONTROL PANEL BUTTON INSTRUCTION: Press the timer button for more than 10 seconds. The single cycle indicator light will flash (When the timer indicator light flashes in the 24h, single cycle indicator light is not working).
- Page 5 Press the time button to adjust the time, the pump must be stopped; otherwise the time cannot be adjusted. There are two operation modes in control panel: continuous mode and single cycle mode. CONTINUOUS MODE: After turning on the pump, the default setting is 24 hours continuous operation (indicator lights flashing in 24 h). To set the desired operation period, this can be done by pressing the timer button;...
- Page 6 REGULAR INSPECTION AND MAINTENANCE 1. Confirm whether screws in the baseboard are installed tightly. If any loose, tighten the screws. 2. Confirm whether the power cords and insulation parts are in good condition. If broken, repair or replace them to prevent the leakage of electricity.
- Page 7 Motor roars, but does not work: The impeller may be blocked. Solution: Have a qualified professional open the motor and remove the rubbish. Low flow: 1. Check whether the filter or hose is blocked or not. Solution: Contact a professional cleaner to clean it. 2.
Need help?
Do you have a question about the 75171 and is the answer not in the manual?
Questions and answers