Changing Fuses - APRILIA TUONO 1000 - 2006 Manual

CAUTION
Do not try to adjust the spark plug gap in
any way.
The gap must be 0.024 – 0.028 in (0.6 –
0.7 mm), otherwise it is necessary to replace
the spark plug.
Make sure the gasket (12) is in good
condition.
TO FIT THE SPARK PLUG
With the gasket (12) in place, screw the
spark plug into the head finger tight.
Tighten the spark plug with the special
spark plug wrench, approximately one-half
turn after it first snugly contacts the cylinder
head.
Spark plug tightening torque setting:
14.47 ftlb (20 Nm).
CAUTION
The spark plug must be properly
tightened, otherwise the engine may
overheat and be seriously damaged.
CAUTION
Do not mix up the spark plug caps (1)
position.
Fit the spark plug cap (1) properly, so that it
does not come off due to the vibrations of
the engine.
NOTE
Repeat the operations described to
remove, check and clean the other (second)
spark plug of the same cylinder and the other
two spark plugs of the second cylinder.
Replace the fuel tank, see page 108
(LIFTING THE FUEL TANK).

CHANGING FUSES

C a r e f u l l y r e a d
(MAINTENANCE).
WARNING
Risk of fire.
Keep fuel and other flammable
substances away from the electrical
components.
CAUTION
Do not repair faulty fuses.
Use only recommended fuses.
Using fuses of an improper capacity
can cause damage to the electrical
system or an electrical fire, which could
result in total destruction of your
vehicle as well as injury to you.
NOTE
If a fuse blows frequently, there
probably is a short circuit or an overload in
the electrical system. If this occurs, take
the vehicle to your Local aprilia Dealer.
1
If an electric component does not work or
works irregularly, or if the vehicle fails to
p a g e 7 9
start, it is necessary to check the fuses.
Your vehicle is equipped with two group
of fuses:
– the 15A auxiliary fuse group (1) placed
on the right side of the fairing, see
page 122 (ARRANGEMENT OF 15A
AUXILIARY FUSES);
– the 30A main fuse group (2) placed under
the rider
(ARRANGEMENT OF 30A MAIN FUSES).
NOTE
Check the fuses in the following
order:
– first the fuses of the 15A auxiliary fuse
group (1);
– second the fuses of the 30A main fuse
group (2).
To check the fuses of the auxiliary fuse
group (1):
Set the ignition switch to "
any accidental short circuit.
use and maintenance TUONO 1000
seat, see page 122
" to avoid
121
USA