Changing The Headlight Bulbs - APRILIA TUONO 1000 - 2006 Manual

1
2
3
CHANGING
THE HEADLIGHT BULBS
Carefully read page 129 (BULBS).
NOTE
Before changing a bulb, check
the fuses, see page 121 (CHANGING
FUSES).
The headlight contains:
The headlight accommodates the following
bulbs:
– Two high-beam bulbs (1).
– Two low-beam bulbs (2).
– Two parking-light bulbs (3).
T h e h i g h - a n d l o w - b e a m b u l b s a r e
identical. If the low beam is burned out and
no spare bulb is available, it is possible to
substitute the high-beam bulb for the low-
beam bulb.
This should only be done to make it
possible to ride a short distance at night to
a shop where a new bulb can be obtained
or home.
130 use and maintenance TUONO 1000
1
2
To replace:
Place the vehicle on the stand, see page
58 (PLACING THE VEHICLE ON THE
STAND).
HIGH- AND LOW-BEAM BULBS
NOTE
Disconnect one connector at a
time to avoid confusing the various
connectors when refitting.
When high- and low-beam bulb connectors
must be removed simultaneously, mark
them with their positions and make sure to
refit them in the correct positions when
assembling.
USA
1
3
2
CAUTION
Never pull on the wiring to disconnect a
bulb connector.
Disconnect the connector (4).
Rotate the lockring counterclockwise
and extract the bulb holder (5).
Fit a new bulb of equal rating.
Refit the bulb holder into the seat and
rotate clockwise to lock in place.
Refit the connector (4).
5
4