Replacing The License Plate Light Bulb - APRILIA TUONO 1000 - 2006 Manual

3
CAUTION
When refitting, make sure that the lens
fits properly into its slot. Tighten the
screw (1) gradually. Do not overtighten
to avoid damaging the lens.
Push down the bulb (3) gently and twist
counterclockwise.
Extract the bulb (3) from its seat.
CAUTION
When fitting the bulb, make sure that
the two locating pegs fit properly into
the slots in the bulb holder.
Install a new bulb of equal rating.
CAUTION
If the reflector (4) comes off its seat,
refit it correctly.
132 use and maintenance TUONO 1000
REPLACING THE LICENSE PLATE
LIGHT BULB
Read page 129 (BULBS) carefully.
Place the vehicle on the stand, see page
77 (PLACING THE VEHICLE ON THE
STAND).
Remove the passenger seat / glove/tool
kit compartment cover, see page 45
(GLOVE/TOOL KIT COMPARTMENT).
4
USA
5
CAUTION
Never pull on the wiring to extract a
bulb holder.
Extract the license plate light bulb holder
(5).
Remove the bulb and fit a new one with
equal rating.
NOTE
Make sure that the bulb fits
correctly into the bulb holder.