Table of Contents
Advertisement
Pull the wheel backwards, removing it from
the swingarm from behind, carefully
removing the disc from the brake caliper.
NOTE
The left spacer ring (10) and the
right spacer ring (11) remain in their seats
on the wheel; collect them if they have
come out.
NOTE
The torque plate (12) of the brake
caliper (13) remains installed on the right
side of the rear fork.
Proceed with care. If the final drive unit
(14) is installed on the flexible coupling
holder (15), do not overturn or rotate the
rear wheel in horizontal position on the rear
sprocket side (A), since the final drive unit
would come off and fall, and this could
damage the rear sprocket (9).
NOTE
If the wheel is in the normal
running position (vertical) or in horizontal
position with the rear sprocket facing
upwards and in both cases secured
against overturning, it is not necessary to
remove the final drive unit.
104
use and maintenance TUONO 1000
9
NOTE
Do not loosen the five nuts (16).
The complete final drive unit must be
withdrawn from the flexible coupling
holder.
Working (B) with both hands on the outer
diameter of the sprocket (9), withdraw
the final drive unit parallel to the wheel
axis.
REASSEMBLY
If the final drive unit has been removed
(14):
NOTE
Introduce the final drive unit,
parallel to the wheel axis, inserting the
flexible couplings in the corresponding
seats on the flexible coupling holder (15).
Working (C) with both hands on the
outer diameter of the sprocket (9), insert
the final drive unit in the flexible coupling
holder (15).
USA
While reassembling the rear wheel, be
careful not to damage the brake line, the
disc and the pads.
NOTE
the left spacer ring (10) and/or the right spacer
ring (11) have come out of their seats on the
wheel:
Fit the left (10) and right (11) spacer rings in
their seats on the wheel with the larger
9
diameter facing the outside of the vehicle
(see figure).
Before proceeding with reassembly, make
sure that the torque plate (12) of the brake
caliper (13) is positioned correctly; the
plate slot must be inserted in the
appropriate stop pin (17) in the inner part
of the right side of the swingarm. Insert the
disc in the brake caliper carefully.
Place the wheel centrally on the
swingarm, on the support (2).
Keep your fingers well away from the
chain and sprocket. You could easily lose
a finger if it is caught between these two
parts. Use heavy work gloves while
installing the rear wheel. Never attempt to
line the rear wheel up using your fingers.
Failure to observe this warning can result
in serious personal injury.
CAUTION
Perform the follow operation only if
CAUTION
WARNING
Hide quick links:
Advertisement
Table of Contents
