LOW BEAM BULB
N
Move the protection element (9) with
your hands.
CAUTION
To extract the bulb electric connector,
do not pull its electric wires.
N
Grasp the bulb electric connector (10),
pull it and disconnect it from the bulb (3).
N
Rotate the bulb socket (11) anticlockwise
and extract it from its seat.
N
Extract the bulb (3) from its seat and re-
place it with a new one of the same type.
NOTE
Insert the bulb in the bulb socket,
making the relevant positioning seats coin-
cide.
94
use and maintenance RSV mille - RSV mille R
Carefully read p. 92 (BULBS).
N
Position the vehicle on the side stand on
firm and level ground.
N
Unscrew and remove the screw (12).
CAUTION
While removing the protection screen,
proceed carefully in order not to break
the cog.
N
Remove the protection screen (13).
CAUTION
Upon reassembly, correctly position the
protection screen in its seat.
Tighten the screw (12) moderately and
carefully, to avoid damaging the protec-
tion screen.
N
Press the bulb (14) slightly and rotate it
anticlockwise.
N
Extract the bulb (14) from its seat.
CAUTION
Insert the bulb in the bulb socket, mak-
ing the two bulb pins coincide with the
relevant guides on the socket.
N
Correctly install a new bulb of the same
type.
CAUTION
If the bulb socket (11) goes out of its
seat, insert it correctly, making the bulb
socket opening coincide with the screw
seat.